Loading problem
by Warit Achavanuntakul · in General Discussion · 01/09/2007 (5:15 pm) · 4 replies
Two quick problems,
1. It seems like when I'm exec'ing too many datablock at once, torque crashes. Is there anyway to tell torque to load one object/datablock at a time, then continue loading next object once its done? I saw loading bar in the sample kit but I can't seem to figure out its code. All i saw was one "exec" after the other.
2. Possibly related to problem number 1, I can't reload my mission if I don't delete all .DSO file and exec them all over again.
Can anyone share any light on these?
1. It seems like when I'm exec'ing too many datablock at once, torque crashes. Is there anyway to tell torque to load one object/datablock at a time, then continue loading next object once its done? I saw loading bar in the sample kit but I can't seem to figure out its code. All i saw was one "exec" after the other.
2. Possibly related to problem number 1, I can't reload my mission if I don't delete all .DSO file and exec them all over again.
Can anyone share any light on these?
About the author
#2
Everything just went dark with red dots when my mouse is over the new window...
01/09/2007 (11:53 pm)
Nothing T_TEverything just went dark with red dots when my mouse is over the new window...
#3
There was no error report in Console log so I have no clue what to do. This is very wierd, when I tell Torque to exec unexisted .cs between my datablock, the code works...
01/11/2007 (3:09 am)
No one faced similar problems?There was no error report in Console log so I have no clue what to do. This is very wierd, when I tell Torque to exec unexisted .cs between my datablock, the code works...
#4
01/11/2007 (9:11 am)
Please use the Torque SDK private forusm for questions like these. 
Torque Owner AllynMcelrath