Print functions? or a Feature request
by Johnny Hill · in Artist Corner · 12/17/2005 (1:10 pm) · 3 replies
Maybe I am not looking, but is there a print feature in Showtool Pro. I like studying the information and particular the bone and joints setups on different characters?
But sometimes I wish I could print out the tree list and have something to look at while I make a model or print out the node rotations so i can setup my skeletons as close to the originals as I can.
There is a lot of info in showtool pro that would be nice to print out if I needed it right there.
But sometimes I wish I could print out the tree list and have something to look at while I make a model or print out the node rotations so i can setup my skeletons as close to the originals as I can.
There is a lot of info in showtool pro that would be nice to print out if I needed it right there.
About the author
#2
12/17/2005 (3:47 pm)
Thanks again Magnus, didnt know (really should read the docs like I should) about that feature thats primarily what I need to look at. I started ahead with my own characters and getting them off of paper. 
#3
I just poked around for a couple of moments to see if I could find anything and that was as close as I could get.
12/17/2005 (4:26 pm)
Well, to tell the truth, I didn't know either. =)I just poked around for a couple of moments to see if I could find anything and that was as close as I could get.
Torque Owner Magnus Blikstad
If you go into the "shape properties" and switch to the "TSDump" tab you can hit refresh and then export to save the information out. It will be located in a file called dtsdump.txt in the showtool folder.