My objects don't show up!
by Matt Vitelli · in Artist Corner · 02/23/2005 (8:17 am) · 3 replies
#2
There's your buggy minimalist showtool. ;)
As for exporting:
Make sure that all the resources linked to each model in max are in the same folder.
Try to use 24/32 bit png or tga images. (Targa is a texel memory HOG)
Is the model at 0x,0y,0z in max? If not, then it is loading up in Torque...but it's probably too far away to see.
Good luck!
02/25/2005 (2:16 pm)
Firstly, you DO have a show tool. Simply make a shortcut to the compiled torque executable; open up the properties of said shortcut and at the very end of the line after Target type -show.There's your buggy minimalist showtool. ;)
As for exporting:
Make sure that all the resources linked to each model in max are in the same folder.
Try to use 24/32 bit png or tga images. (Targa is a texel memory HOG)
Is the model at 0x,0y,0z in max? If not, then it is loading up in Torque...but it's probably too far away to see.
Good luck!
Torque Owner Todd D. Degani
On a side note, your 12 and have a copy of Max? I know quite a few people older than you who wish they were that lucky :).