Not executing right
by James A. Burke · in Torque Game Engine · 02/26/2004 (2:45 am) · 0 replies
Hi,
I have had some difficulty in compiling Torque, but that isn't my problem. I decided to put Torque on my laptop. I installed Torque, then I went and compiled. I still have missing symbols so I just ran it without debugging (with MSVC++.NET 2003). It ran fine. I then re-installed Torque on my PC, compiled, ran without debugging and then when it brought up the second Torque window (after the DOS window) it took the cursor to the bottom left of the screen and it didn't run. I tried to click on it and it just took the cursor to the bottom left again. I have just copied the files from my laptop to the computer (compiled files) and it runs.
I'm not sure what is going on, the settings are the same as the laptop. EXCEPT, I ran the C:\Torque\vc7\VC7 .cc compiling.reg file, would this have caused it?
Thanks,
James
I have had some difficulty in compiling Torque, but that isn't my problem. I decided to put Torque on my laptop. I installed Torque, then I went and compiled. I still have missing symbols so I just ran it without debugging (with MSVC++.NET 2003). It ran fine. I then re-installed Torque on my PC, compiled, ran without debugging and then when it brought up the second Torque window (after the DOS window) it took the cursor to the bottom left of the screen and it didn't run. I tried to click on it and it just took the cursor to the bottom left again. I have just copied the files from my laptop to the computer (compiled files) and it runs.
I'm not sure what is going on, the settings are the same as the laptop. EXCEPT, I ran the C:\Torque\vc7\VC7 .cc compiling.reg file, would this have caused it?
Thanks,
James
