Game Development Community

Fish in Water

by SETTIMO EUGEN CRISTIAN · in Torque Game Engine · 11/11/2009 (9:15 pm) · 5 replies

Hi to all,

my question today is: moving fish in water..
I don't want blank water..
I want to put fish it in..
i have dts fish with animation..but my problme is to start of use is..
Anyone have little tutorial about moving fish or animal etc... ai..?



Thank you.
NextNext Thread
PrevPrevious Thread
More from Torque Game Engine


Torque 3D Owner Aun Taraseina
#1
11/11/2009 (9:48 pm)
You could setup the fish as an AI and create a path for in under water. When the Game starts run the fish on the path.

Torque Owner Mike Rowley
Mike Rowley
#2
11/11/2009 (11:53 pm)
There is a problem with making fish swim and birds fly in torque.
What you'll need to do is to make an invisable pole that the fish rides on . (the pole follows the bottom of the lake) You'll need to look at the aiPlayer.cs in server/scripts/ to see how to place your fish on a path and get it going. Hope that helps a bit.

Torque Owner SETTIMO EUGEN CRISTIAN
Set Dev Studio
#3
11/12/2009 (3:14 pm)
Ok, thank you all.. :)
If must be real:) the water must have fish:)
or shark:)

Torque Owner Mike Rowley
Mike Rowley
#4
11/12/2009 (11:55 pm)
You are correct. There used to be a kit sold here that included examples of fish and birds. It's been taken down, and I never got a reply when I asked if it could be given away. (or even upgraded)

Torque Owner SETTIMO EUGEN CRISTIAN
Set Dev Studio
#5
11/13/2009 (8:59 am)
arteria3d have resources about..
i remember the nature pack.. but i don't see it in gg shop..